1. |
Install in the reverse order of removal.
|
•
|
Adding Automatic Transaxle Fluid(ATF).
(Refer to Hydraulic System - "Fluid")
|
•
|
Perform Transaxle Control Module(TCM) learning after replacing
the solenoid valve to prevent slow transaxle response, jerky
acceleration and jerky startup.
(Refer to Automatic Transaxle Control System - "Repair
procedures")
|
•
|
Replace the gasket (A) before reinstalling the valve body
cover.
|
|
1.
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
2.
Remove the drain plug (A) and dr ...
Underdrive brake control solenoid valve(UD/B) is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic pressure
inside the underdrive brake.
...
See also:
Air bag inflation conditions
Front air bags
Front air bags are designed to inflate in a frontal collision depending on the
intensity, speed or angles of impact of the front collision.
Side impact and/or curtain air bags ...
Relay Box (Passenger Compartment) Removal
Passenger Compartment Junction Box (SJB)
1.
Disconnect the negative(-) battery terminal.
2.
Remove the crash pad lower pan ...
Field Effect Transistor (FATC) Inspection
1.
Turn the ignition switch ON.
2.
Manually operate the control switch and measure the voltage of
the blower motor.
3. ...