Kia Soul: Field Effect Transistor (FATC) Inspection
Kia Soul 2014-2019 PS Service Manual / Heating,Ventilation And Air Conditioning / Blower / Field Effect Transistor (FATC) Inspection
| 1. |
Turn the ignition switch ON.
|
| 2. |
Manually operate the control switch and measure the voltage of
the blower motor.
|
| 3. |
Select the control switch to raise the voltage until high speed.
|
| Segment |
Manual Blower Voltage
(V) |
|
| A/C ON |
A/C OFF |
|
| 1 |
3.8 |
3.4 |
| 2 |
4.5 |
4.5 |
| 3 |
5.8 |
5.8 |
| 4 |
7.0 |
7.0 |
| 5 |
8.6 |
8.6 |
| 6 |
9.8 |
9.8 |
| 7 |
11.3 |
11.3 |
| 8 |
Battery (+) |
|
| 1. |
If the measured voltage is not within specification, substitute
with a known-good field effect transistor and check for proper operation.
|
| 2. |
Replace the field effect transistor if it is proved that there
is a problem with it.
|
Blower Resistor (Manual) Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
...
Field Effect Transistor (FATC) Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
...
See also:
Battery replacement
The transmitter uses a 3 volt lithium battery which will normally last for several
years. When replacement is necessary, use the following procedure.
1. Insert a slim tool into the slot and gen ...
Components
1. Cylinder head cover
2. Cylinder head cover gasket
3. Cylinder head assembly
4. Cylinder head gasket
5. Camshaft position sensor
6. Camshaft bearing cap
7. Camshaft ...
Side Impact Sensor (SIS). Description
Side Impact Sensor (SIS) system consists of two P-SIS which are installed
at each center of the front door module (LH and RH) and two SIS which are installed
at each center pillar nearby (LH ...