Kia Soul: SRS Control Module (SRSCM). Installation
1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
3. |
Install the SRSCM with the SRSCM mounting bolts.
|
4. |
Connect the SRSCM harness connector.
|
5. |
Install the rear heating joint duct.
|
6. |
Install the floor console.
(Refer to Body - "Floor console")
|
7. |
Reconnect the battery negative cable.
|
8. |
After installing the SRSCM, confirm proper system operation:
|
SRSCM is sensing the vehicle rollover. SAB, CAB, BPT will be able
to expanse if mechanic moves the SRSCM on vehicle during IGN ON state.
For this reason, turn the IGN OFF surely and then remove the SRSCM from
vehicle.
|
SRS Control Module (SRSCM). Removal
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...SRS Control Module (SRSCM). Variant coding
After replacing the SRSCM with a new one, MUST perform the “Variant Coding” procedure. 1. ...See also:
Control Shaft Complete Installation
1.
Install in the reverse order of removal.
•
...
Reporting safety defects
If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in ad ...
Drive Plate Components
1. Adapter plate
2. Drive plate
...