Kia Soul: SRS Control Module (SRSCM). Variant coding
|
■ On-Line type on GDS |
1. |
Ignition "OFF", connect scantool.
|
2. |
Ignition "ON" & Engine "OFF" select vehicle name and airbag system.
|
3. |
Select Variant coding mode.
|
4. |
Follow steps on the screen as below.
|
1) Screen of Retrying the Variant coding after finishing variant
coding
2) Screen of communication failure
|
1) Screen of Retrying the Variant coding after finishing variant
coding
|
SRS Control Module (SRSCM). Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...Front Impact Sensor (FIS). Description
The Front Impact Sensor (FIS) is installed in the Front End Module (FEM). They are remote sensors that detect acceleration due to a collision at its mounting location. The primary purpose of ...See also:
Defogging logic
To reduce the possibility of fogging up the inside of the windshield, the air
intake or air conditioning are controlled automatically according to certain conditions
such as
or
position. T ...
If engine turns over normally but does not start
1.Check the fuel level.
2.With the ignition switch in the LOCK position, check all connectors at the
ignition coils and spark plugs. Reconnect any that may be disconnected or loose.
3.Check the fu ...
Illuminated ENGINE START/STOP button
Whenever the front door is opened, the ENGINE START/STOP button will illuminate
for your convenience.
The light will go off after about 30 seconds when the door is closed. When all
entrances ...