| •
|
Do not turn the ignition switch ON and do not connect
the battery cable while replacing the front impact sensor.
|
|
|
1. |
Install the new front impact sensor.
|
|
2. |
Tighten the front impact sensor (B) mounting bolt.
Tightening torque :
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.7 ~ 7.3 lb-ft)
|
|
|
3. |
Connect the front impact sensor connector (A).
|
|
4. |
Install the air duct. [Left side only]
|
|
5. |
Reconnect the battery negative cable.
|
|
6. |
After installing the Front Impact Sensor, confirm proper system
operation:
| A. |
Turn the ignition switch ON the SRS indicator light should
be turned on for about six seconds and then go off.
|
|
•
Removal of the airbag must be performed according to the
precautions / procedures de ...
Side Impact Sensor (SIS) system consists of two P-SIS which are installed
at each center of the front door module (LH and RH) and two SIS which are installed
at each center pillar nearby (LH ...
See also:
Cruise Control Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver airbag module.
(Refer to the RT group)
3.
...
Door lock/unlock in an emergency situation
If the smart key does not operate normally, you can lock or unlock the doors
by using the mechanical key.
1.Press and hold the release button (1) and remove the mechanical key (2).
2.Insert the ...
Rear Disc Brake. Inspection
Rear brake disc thickness check
1.
Check the brake pads for wear and fade.
2.
Check the brake disc for damage and cracks.
...
Kia Soul: Front Impact Sensor (FIS). Installation
Front Impact Sensor (FIS). Removal
Side Impact Sensor (SIS). Description