Kia Soul: Accelerator Position Sensor (APS). Description and Operation
Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS). Description and Operation
Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal
module and detects the rotation angle of the accelerator pedal. The APS is one
of the most important sensors in engine control system, so it consists of the
two sensors which adapt individual sensor power and ground line. The second
sensor monitors the first sensor and its output voltage is half of the first
one. If the ratio of the sensor 1 and 2 is out of the range (approximately 1/2),
the diagnostic system judges that it is abnormal.
Rail Pressure Sensor (RPS). Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine
speed. ...
Accelerator Position Sensor (APS). Specifications
Specification
Accelerator
Position
Output Voltage (V)
[Vref = 5V]
APS1
APS2
C.T
0.7 ~ 0.8
0.28 ~ 0.48
W.O.T
3.8 ...
See also:
Receiver-Drier Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with a L wrench
(A).
Tightening to ...
Panorama Sunroof Switch Components
...
Ending voice recognition
While Voice Recognition is operating Press and hold the key on the steering remote controller
While using voice command, pressing any steering wheel control or a different key will end vo ...