Kia Soul: Rail Pressure Sensor (RPS). Repair procedures - Engine Control System - Engine Control / Fuel SystemKia Soul: Rail Pressure Sensor (RPS). Repair procedures

Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Rail Pressure Sensor (RPS). Repair procedures

Inspection

1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
Condition
 Output Voltage (V)
Idle
  Approx. 1.2
1,500 rpm
 2.2 ~ 2.5
6,300 rpm
  Approx. 3.0

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line").
3.
Remove the Alternator.
(Refer to Engine Electrical System - "Alternator")
4.
Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.

Installation

  
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Install in the reverse order of removal.
Rail Pressure Sensor mounting:
29.4 ~ 34.3 N.m (3.0 ~ 3.5 kgf.m, 21.7 ~ 25.3 lb-ft)
    Rail Pressure Sensor (RPS). Schematic Diagrams
    Circuit Diagram (M/T) (A/T) ...

    Accelerator Position Sensor (APS). Description and Operation
    Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important senso ...

    See also:

    Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Specifications
    Direct control VFS[OD/C] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 500.14 ~ 9.81 (5.1 ~ 0.1, 72.54 ~ 1.42) Current value(mA) ...

    Room Lamp Inspection
    1. Check that the switch operates properly after disconnecting the room lamp connector (A). Room Lamp Personal Lamp ...

    Tachometer
    The tachometer indicates the approximate number of engine revolutions per minute (rpm). Use the tachometer to select the correct shift points and to prevent lugging and/or over-revving the engi ...