Kia Soul: Removal
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
|
3. |
Remove the steering column upper and lower shrouds.
(Refer to Body - "Steering Column Shroud Panel")
|
4. |
Remove the wiper switch.
(Refer to "Multifunction switch")
|
5. |
Remove the ignition switch after loosening disconnecting the
ignition switch 6P connector (A).
|
6. |
Remove the ignition switch assembly (A) after loosening the
mounting bolts.
|
7. |
If it is necessary to remove the key lock cylinder (A), it
is in the order as below.
|
Inspection
1. Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column. ...Installation
1. Install the key lock cylinder. 2. Install the key warning and immobilizer connector. 3. ...See also:
Driver's and passenger's front air bag
Driver’s front air bag
Passenger’s front air bag
Your vehicle is equipped with an Advanced Supplemental Restraint (Air Bag) System
and lap/shoulder belts at both the driver and passenger s ...
Satellite radio reception
You may experience difficulties in receiving SIRIUS satellite radio signals in
the following situations.
If you are driving in a tunnel or a covered parking area.
If you are driving beneath ...
Opening the hood
1.Pull the release lever to unlatch the hood. The hood should pop open slightly.
Open the hood after turning off the engine on a flat surface, shifting the shift
lever to the P(Park) position for ...