Kia Soul: Rear Wiper Motor Installation - Rear Wiper/Washer - Body Electrical SystemKia Soul: Rear Wiper Motor Installation

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Rear Wiper/Washer / Rear Wiper Motor Installation

1.
Install the rear wiper motor assembly.
Tightening torque Bolt :
6.9~10.8 Nm (0.7~1.1 kgf.m, 5.1~8.0 lbf.ft)
2.
Install the tailgate trim.
3.
Install the rear wiper arm cap after tighting the nut.
Tightening torque Nut :
3.9~6.9 N.m (0.4~0.7 kgf.m, 2.9~5.1 lbf.ft)
4.
Set the rear wiper blade and to the lowest defogger heat line and tailgate glass.
A : Auto stop position
    Rear Wiper Motor Removal
    1. Detach the rear wiper cap (A). 2. Remove the rear wiper arm & blade (B) after removing rear wiper HEX nut ...

    Rear Washer Switch Inspection
    1. Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch. ...

    See also:

    Certification label
    The certification label is located on the driver's door sill at the center pillar. This label shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gross Ve ...

    Center Pillar Trim Replacement
    [Center pillar lower trim]    • Put on gloves to protect your hands. ...

    Battery Sensor Description
    Vehicles have many control units that use more electricity. These units control their own system based on information from diverse sensors. It is important to have a stable power supply as th ...