[Center pillar lower trim]
•
|
Put on gloves to protect your hands.
|
|
•
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
•
|
Use a plastic panel removal tool to remove interior trim
pieces to protect from marring the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Remove the front door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
|
2. |
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
|
3. |
Slighty remove the front door body side weatherstrip.
|
4. |
Slighty remove the rear door body side weatherstrip.
|
5. |
Remove the center pillar lower trim.
(1) |
To remove the seat belt anchor pretensioner (C), keep
on pushing the lock pin (A) as arrow direction. And then remove
the seat belt after pushing the lock pin (B).
|
(2) |
Using a screwdriver or remover, remove the center pillar
lower trim (A).
|
|
6. |
Install in the reverse order of removal.
• |
Replace any damaged clips.
|
|
|
[Center pillar upper trim]
•
|
Put on gloves to protect your hands.
|
|
•
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
•
|
Use a plastic panel removal tool to remove interior trim
pieces to protect from marring the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Remove the center pillar lower trim.
|
2. |
After loosening the mounting bolt, then remove the center pillar
upper trim (A).
|
3. |
Install in the reverse order of removal.
• |
Replace any damaged clips.
|
|
|
1. Center pillar lower trim
2. Center pillar upper trim
...
1. Rear transverse trim
...
See also:
Blade inspection
Commercial hot waxes applied by automatic car washes have been known to make
the windshield difficult to clean.
Contamination of either the windshield or the wiper blades with foreign matter
ca ...
Manual climate control system
1. Turn the ignition switch to the ON position.
2. Turn the mode selection knob to the defrost position ().
3. Push the air intake control button at least 5 times within 3 seconds.
The indicator ...
Antenna Inspection
Antenna Cable
1.
Remove the antenna jack from the audio unit and antenna.
2.
Check for continuity between the center poles of antenna cable. ...