•
|
Put on gloves to protect your hands.
|
|
•
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
•
|
Use a plastic panel removal tool to remove interior trim
pieces to protect from marring the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Remove the lock hook (B) and then remove the rear seat armrest
(A).
|
2. |
Press the rear seat armrest (A) in the direction of the arrow
in the below picture, and then remove it by pulling it up.
• |
Rear seat armrest installment
|
|
(1) |
Install the cap (A) on the side part of the armrest.
[LH]
[RH]
|
(2) |
Put the left side part (A) of the armrest into the hole
(B).
|
(3) |
Push the armrest (A) sidewards in the direction of the
arrow, and then install it.
|
|
1. Rear seat latch assembly
...
See also:
Description
EPS (Electric power steering, Column assist type) system uses an electric
motor to assist the steering force and it is an engine operation independent
steering system.
EPS control module ...
Air intake control
This is used to select outside (fresh) air position or recirculated air position.
To change the air intake control position, push the control button.
Recirculated air position
The indicator lig ...
Front Hub / Knuckle Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) fro ...