Inspection
|
1. |
Connect the GDS on the Data Link Connector (DLC).
|
|
2. |
Measure the output voltage of the MAPS at idle and IG ON.
Specification:
Refer to "Specification"
|
|
Removal
|
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
|
2. |
Disconnect the manifold absolute pressure sensor connector (A).
|
|
3. |
Remove the installation bolt (B), and then remove the sensor from
the surge tank.
|
Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
| •
|
Insert the sensor in the installation hole and be careful
not to damage.
|
|
|
1. |
Install in the reverse order of removal.
Manifold absolute pressure sensor
installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
Circuit Diagram
(M/T)
(A/T)
...
Description
Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute
Pressure Sensor and detects the intake air temperature.
To calculate precise air quantity, correction o ...
See also:
Water pump Removal
1.
Drain the coolant.
(Refer to Cooling System - "Coolant")
2.
Remove the drive belt.
(Refer to Timing System - " ...
Starting the engine
WARNING
Always wear appropriate shoes when operating your vehicle. Unsuitable shoes
(high heels, ski boots,etc.) may interfere with your ability to use the brake and
accelerator pedal.
1.Make su ...
ESC Operation Mode
1.
STEP 1
The ESC analyzes the intention of the driver.
2.
STEP 2
It analyzes the movement of the ESC vehicle.
...
Kia Soul: Manifold Absolute Pressure Sensor (MAPS). Repair procedures
Manifold Absolute Pressure Sensor (MAPS). Schematic Diagrams
Intake Air Temperature Sensor (IATS). Description and Operation