Kia Soul: Cylinder Block Reassembly - Cylinder Block - Engine Mechanical SystemKia Soul: Cylinder Block Reassembly

Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Cylinder Block / Cylinder Block Reassembly

1.
Install in the reverse order of disassembly.
  
In case the cylinder block is replaced with a new one, select the proper crankshaft main bearing and the piston according to the crankshaft journal bore mark and the cylinder bore mark on the cylinder block.
•
Crankshaft main bearing selection
(Refer to Cylinder Block Assembly - "Crankshaft")
•
Piston selection
(Refer to Cylinder Block Assembly - "Piston and Connecting Rod")
    Cylinder Block Inspection
    1. Using a gasket scraper, remove all the gasket material from the top surface of the cylinder block. 2. Using a soft brush and solvent, th ...

    Cylinder Head Assembly
    ...

    See also:

    Failure Diagnosis
    1. In principle, ESC and TCS controls are prohibited in case of ABS failure. 2. When ESC or TCS fails, only the failed system control is pr ...

    Windshield wipers
    Operates as follows when the ignition switch is turned ON. MIST : For a single wiping cycle, push the lever upward and release it with the lever in the OFF position. The wipers will operate conti ...

    Front Driveshaft Replacement
    1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) fro ...