Kia Soul: Brake Switch. Installation - Brake System - Brake SystemKia Soul: Brake Switch. Installation

Kia Soul 2014-2019 PS Service Manual / Brake System / Brake System / Brake Switch. Installation

1.
Fix the brake pedal arm and insert fully the brake switch as hiding contact part.
2.
After inserting, turn the brake switch 45В° clockwise, and then assemble locking plate by pushing.
3.
Confirm the gap between brake switch and bracket.
Brake clearance (A):
1.0 ~ 2.0 mm (0.04 ~ 0.08 in.)

4.
Connect the brake switch connector (A).
    Brake Switch. Inspection
    1. Check the stop lamp switch. (1) Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is ...

    Brake Switch. Adjustment
    Brake switch clearance adjustment If the gap between brake switch and bracket is not 1.0 ~ 2.0mm(0.04~ 0.08in), conform to below. 1. Disconnect the brake swi ...

    See also:

    Piston and Connecting Rod Components
    1. Piston ring 2. Piston 3. Piston pin 4. Connecting rod 5. Connecting rod upper bearing 6. Connecting rod lower bearing 7. Connecting rod bearing cap ...

    Instrument panel overview
    1. Instrument Cluster 2. Light Control / Turn Signals 3. Audio Controls* 4. Advanced Lighting Speaker* 5. Driver's Front Air Bag 6. Auto Cruise Controls* 7. Wiper/Washer 8. Vent Controls ...

    Components
    1. ESC Control Module (HECU) 2. Front Wheel Speed Sensor 3. Rear Wheel Speed Sensor 4. Yaw-late & Lateral G Sensor 5. Steering Wheel Angle Sensor 6. ABS Warning Lamp ...