Kia Soul: Variable Intake Solenoid (VIS) Valve. Repair procedures - Engine Control System - Engine Control / Fuel SystemKia Soul: Variable Intake Solenoid (VIS) Valve. Repair procedures

Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve. Repair procedures

Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between VIS valve terminals 1 and 2.
Specification: Refer to "Specification"

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the variable intake solenoid valve connector (A).
3.
Disconnect the vacuum hoses (B) from the valve.
4.
Remove the valve (C) from the surge tank.

Installation

  
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
  
•
Use care to keep foreign material out of the valve.
1.
Install in the reverse order of removal.
    Variable Intake Solenoid (VIS) Valve. Schematic Diagrams
    Circuit Diagram (M/T) (A/T) ...

    Fuel Pressure Control Valve. Description and Operation
    Description Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on ...

    See also:

    Component Location
    1. Hood switch 2. BCM & RF receiver 3. Key warning switch 4. Front door lock actuator & switch 5. Rear door lock actuator & switch 6. Tailgate ...

    MENU : My Music Mode
    In My Music mode, press the key to set the Repeat, Random, Information, Delete, Delete All, and Delete Selection features. ...

    Oil Pump. Components
    1. Reaction shaft support assembly 2. Oil pump housing 3. Driven gear 4. Drive gear 5. Oil seal 6. Bush-Housing 7. Reaction shaft 8. Bush- Reaction shaft 9. Slee ...