1. |
General Function
A. |
Auto-learn takes place only once per Ignition cycle.
|
B. |
On successful completion, 4 road wheel sensor ID's are
latched into memory for monitoring.
|
C. |
Until Auto-learn completes, previously learned sensors
are monitored for under inflation / leak warnings.
|
|
2. |
General Conditions to Learn New Sensors:
A. |
Receiver must determine that it is confident that sensor
is not temporary:
|
2) |
Uses confidence reduction of previously learned
sensors.
|
|
B. |
Typical time at driving continuously over 15.5 mph(25
kph) to learn a new sensor is up to 20 minutes.
|
|
3. |
General Conditions to Un-Learn a sensor that is removed:
A. |
It takes less than 20 minutes at 15.5 mph(25 mph).
|
B. |
Confidence reduction is dependent on time which vehicle
is driven at speed greater than or equal to 12.4 mph(20 kph).
|
|
1.
Mode
(1)
Virgin State
A.
The receiver as a sole part is shipped in this
state. ...
When the receiver first arrives for replacement:
1)
It will be in Virgin State.
...
See also:
Special Service Tools
Tool Name / Number
Illustration
Description
Engine support fixture (bar)
09200-3N000
Used for holding engine assembly when removing
/ in ...
Steering gear box, linkage & boots/lower arm ball joint
With the vehicle stopped and engine off, check for excessive free-play in the
steering wheel.
Check the linkage for bends or damage. Check the dust boots and ball joints for
deterioration, cracks ...
Installation
1.
Install in the reverse order of removal.
If the oil seal on the transaxle case side is d ...