Kia Soul: SS-A Solenoid Valve(ON/OFF). Removal - Automatic Transaxle Control System - Automatic Transaxle SystemKia Soul: SS-A Solenoid Valve(ON/OFF). Removal

Kia Soul 2014-2019 PS Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / SS-A Solenoid Valve(ON/OFF). Removal

1.
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
2.
Remove the drain plug (A) and drain the ATF totally and then reinstall the drain plug.
Tightening torque :
33.3 ~ 43.1 N.m (3.4 ~ 4.4 kgf.m, 24.6 ~ 31.8 lb-ft)

  
Must be replaced with new gasket when installing the drain plug.
3.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner")
4.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
5.
Remove the wiring bracket (A).
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

6.
Remove the air breather hose (A).
7.
Remove the valve body cover (B).
Tightening torque:
11.8 ~ 13.7 N.m (1.2 ~ 1.4 kgf.m, 8.7 ~ 10.1 lb-ft)

8.
Remove the solenoid valve connector (B) and the oil temperature sensor (A).
9.
Remove the solenoid valve (B) after removing the solenoid support (A).
    SS-A Solenoid Valve(ON/OFF). Inspection
    1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector (A). 3. Measure resistance bet ...

    SS-A Solenoid Valve(ON/OFF). Installation
    1. Installation is the reverse of removal.    • ...

    See also:

    Floor mat anchor(s)
    When using a floor mat on the floor carpet, make sure it attaches to the floor mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward. WARNING - After market floor mat Do ...

    Manual climate control system
    1. Fan speed control knob 2. Mode selection button 3. Temperature control knob 4. Air intake control button (fresh/recirculated) 5. Front window defroster button 6. Rear window defroster button ...

    System operation
    Ventilation 1. Set the mode to the position. 2. Set the air intake control to the outside (fresh) air position. 3. Set the temperature control to the desired position. 4. Set the fan speed con ...