Kia Soul: Smart Key Unit Removal
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the main crash pad assembly.
(Refer to Body - "Main Crash Pad Assembly")
|
3. |
Loosen the mounting bolts and nut from the smart key unit
bracket.
|
4. |
Remove the smart key unit (B) after disconnecting the connector
(A) from the smart key unit.
|
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the floor console assembly.
(Refer to Body - "Floor Console Assembly")
|
3. |
Disconnect the connector (A) from the interior antenna.
|
4. |
Remove the interior antenna (A) after loosening the mounting
nuts.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the rear seat cushion assmebly.
(Refer to Body - "Rear Seat Assembly")
|
3. |
Remove the interior antenna 2 (A). (in the order as below)
|
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
|
3. |
Disconnect the connector (A), then remove the rear bumper
antenna (B) with loosening the mounting screws.
|
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the front left wheel guard.
|
3. |
Remove the buzzer (B) after disconnecting the connector (A).
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door module.
(Refer to Front Door - "Front Door Module")
|
3. |
Remove the hole plug (A).
|
4. |
After loosening the mounting bolt, then remove the front door
outside handle cover (B).
|
5. |
Remove the front door outside handle (A) by sliding it rearward.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the tailgate trim.
(Refer to Body - "Tail Gate Trim")
|
3. |
Disconnect the tailgate open switch connector (A).
|
4. |
Remove the tailgate switch (A).
|
Smart Key Unit Inspection
Smart Key Unit - Refer to Smart key System - "Smart key Diagnostic" Smart Key Switch - Refer to Smart ke ...Smart Key Unit Installation
Smart Key Unit 1. Install the smart key unit. 2. Connect the connector and install the smart key unit. ...See also:
Power Seat Control Switch Inspection
1.
With the power seat switch in each position, make sure that
continuity exists between the terminals below. If continuity is
not as specified, replace the po ...
Battery replacement
The transmitter uses a 3 volt lithium battery which will normally last for several
years. When replacement is necessary, use the following procedure.
1. Insert a slim tool into the slot and gen ...
Adding equipment to or modifying your air bag-equipped vehicle
If you modify your vehicle by changing your vehicle's frame, bumper system, front
end or side sheet metal or ride height, this may affect the operation of your vehicle's
air bag system. ...