Kia Soul: Rear Oil Seal Installation - Cylinder Block - Engine Mechanical SystemKia Soul: Rear Oil Seal Installation

Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Installation

1.
Install the rear oil seal.
(1)
Apply engine oil to a new oil seal lip.
(2)
Using the SST(09231-H1100, 09231-2B200) and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

2.
MT : Install the flywheel.
(Refet to Cylinder Block - "Flywheel")
3.
AT : Install the drive plate.
(Refet to Cylinder Block - "Drive Plate")
4.
Install the transaxle assembly.
(Refer to Manual Transaxle System - "Manual Transaxle")
(Refer to Automatic Transaxle System - "Automatic Transaxle")
    Rear Oil Seal Removal
    1. Remove the transaxle assembly. (Refer to Manual Transaxle System - "Manual Transaxle") (Refer to Automatic Transaxle System - "Automatic Transa ...

    Piston and Connecting Rod Components
    1. Piston ring 2. Piston 3. Piston pin 4. Connecting rod 5. Connecting rod upper bearing 6. Connecting rod lower bearing 7. Connecting rod bearing cap ...

    See also:

    Tailgate unlocking
    Using the tailgate handle button 1.Carry the smart key. 2.Press the tailgate handle button. 3.When all doors are locked, the hazard warning lights will blink two times. Using the button on the sma ...

    On-board Refueling Vapor Recovery (ORVR) valve Removal
    1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Remove the fuel pump. (Refer to Fuel System - "Fuel Pump&qu ...

    Antenna
    Your vehicle uses a roof antenna to receive AM or/and FM broadcast signals. This antenna is removable. To remove the roof antenna, turn it counterclockwise. To install the roof antenna, turn it c ...