Kia Soul: Knock Sensor (KS). Knock Sensor (KS). - Engine Control System - Engine Control / Fuel SystemKia Soul: Knock Sensor (KS). Knock Sensor (KS).

Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Knock Sensor (KS). Knock Sensor (KS).

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the engine room under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
3.
Disconnect the knock sensor connector (A).
4.
Remove the mounting bolt (A), and then remove the sensor (B) from the cylinder block.

Installation

  
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Install in the reverse order of removal.
Knock sensor mounting bolt:
18.6 ~ 24.5 N.m (1.9 ~ 2.5 kgf.m, 13.7 ~ 18.1 lb-ft)
    Knock Sensor (KS). Schematic Diagrams
    Circuit Diagram (M/T) (A/T) ...

    Heated Oxygen Sensor (HO2S). Description and Operation
    Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies ...

    See also:

    Pairing through [PHONE] Setup
    Press the key Select [Phone] Select [Pair Phone] Select TUNE knob The following steps are the same as those described in the section "When No Devices have been Paired&q ...

    Temperature control
    The temperature will increase to the maximum (HI) by pushing the button (). The temperature will decrease to the minimum (Lo) by pushing the button (). When turning the knob, the temperature will ...

    Starting Bluetooth® Wireless Technology Audio
    Press the key to change the mode in order of USB➟AUX ➟My Music➟BT Audio. If BT Audio is selected, Bluetooth® Wireless Technology audio will start playing. ϭ ...