Kia Soul: Inspection - maincat - Clutch SystemKia Soul: Inspection

Kia Soul 2014-2019 PS Service Manual / Clutch System / maincat / Inspection

Signal Circuit Inspection
1.
Check ignition lock switch pull-up voltage
(1)
IG KEY "OFF", ENGINE "OFF".
(2)
Disconnect ignition lock switch connector.
(3)
IG KEY "ON".
(4)
Measure the voltage between signal terminal of ignition lock switch harness connector and chassis ground.
Specification : 11.5V ~ 13.0V
2.
Check open in ignition lock switch signal circuit
(1)
IG KEY "OFF", ENGINE "OFF".
(2)
Disconnect ignition lock switch connector and ECM connector.
(3)
Check continuity between signal terminal of ignition lock switch signal harness connector and ECM harness connector.
Specification : Continuity ( below 1.0Ω )
Ground Circuit inspection
1.
IG KEY "OFF", ENGINE "OFF".
2.
Disconnect ignition lock switch connector.
3.
Check continuity between ignition lock switch signal harness connector terminal 4 and chassis ground.
Specification : Continuity ( below 1.0Ω )
Component Inspection
1.
Remove the clutch & ignition lock switch.
2.
Rotate the Ignition lock switch lever to the direction of the arrow to check the continuity.

Clutch pedal position
 Ignition lock switch
Released
 Open
Fully pressed
 Continuity

    maincat
    ...

    Removal
    1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the ignition lock switch connector (A). ...

    See also:

    Front Door Outside Handle Component Location
    1. Front door outside handle ...

    Rear Door Trim Replacement
       • Put on gloves to protect your hands. ...

    SCAN
    Press the key Briefly pressing the key (under 0.8 seconds): The broadcast frequency increases and previews each broadcast for 5 seconds each. After scanning all frequencies, returns and ...