Kia Soul: Heated Oxygen Sensor (HO2S). Repair procedures - Engine Control System - Engine Control / Fuel SystemKia Soul: Heated Oxygen Sensor (HO2S). Repair procedures

Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S). Repair procedures

Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 2 and 5 [B1/S1].
4.
Measure resistance between the HO2S terminals 3 and 4 [B1/S2].
5.
Check that the resistance is within the specification.
Specification: Refer to “Specification”

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the connector (A), and then remove the sensor (B).
  
Note that the SST (Part No.: 09392-1Y100 or 09392-2H100) is useful when removing the heated oxygen sensor.
[Bank 1 / Sensor 1]

[Bank 1 / Sensor 2]

Installation

  
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
  
•
DON’T use a cleaner, spray, or grease to sensing element and connector of the sensor because oil component in them may malfunction the sensor performance.
•
Sensor and its wiring may be damaged in case of contacting with the exhaust system (Exhaust Manifold, Catalytic Converter, and so on).
1.
Install in the reverse order of removal.
Heated oxygen sensor mounting:
39.2 ~ 49.1 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)
    Heated Oxygen Sensor (HO2S). Schematic Diagrams
    Circuit Diagram (M/T) (A/T) ...

    Rail Pressure Sensor (RPS). Description and Operation
    Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built ...

    See also:

    Record your key number
    The key code number is stamped on the bar code tag attached to the key set. Should you lose your keys, this number will enable an authorized Kia dealer to duplicate the keys easily. Remove the b ...

    External Amplifier Installation
    1. Install the external amplifier after connecting the connector.    ...

    SEEK
    Press the  key Briefly pressing the key (under 0.8 seconds): Automatically searches for the next station. Pressing and holding the key (over 0.8 seconds): While holding the key, freq ...