Kia Soul: Dynamic Damper Replacement
Kia Soul 2014-2019 PS Service Manual / Driveshaft and axle / Driveshaft Assembly / Dynamic Damper Replacement
| 1. |
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
|
| 2. |
Remove the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ joint”)
|
| 3. |
Remove the remove the both side of band (B) of the dynamic damper
(A).
|
| 4. |
Fix the driveshaft (A) with a vice (B) as illustrated.
|
| 5. |
Apply soap powder on the shaft to prevent being damaged between
the shaft spline and the dynamic damper when the dynamic damper is removed.
|
| 6. |
Seperate the dynamic damper (A) from the shaft (B) carefully.
|
Dynamic Damper Components
1. BJ assembly
2. BJ circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
...
Dynamic Damper Installation
1.
Apply soap powder on the shaft to prevent being damaged between
the shaft spline and the dynamic damper.
2.
Install the dynamic damper.
...
See also:
Components Operations
PCM (Power Train Control Module)
1.
The PCM(ECM) (A) carries out a check of the ignition key using
a special encryption algorithm, which is programmed into the ...
To resume cruising speed at more than approximately 25 mph (40 km/h)
If any method other than the CRUISE ON-OFF switch was used to cancel cruising
speed and the system is still activated, the most recent set speed will automatically
resume when the RES+ switch is ...
Components
1. Windshield glass
2. Windshield glass moulding
...