Kia Soul: Automatic transaxle Inspection
Fluid level Check |
Automatic Transaxle Fluid(ATF) oil level check is usually unnecessary
during scheduled services. But if fluid leak is found, perform the fluid
level check procedure after repair is completed.
|
When checking the fluid level, be careful not to enter dust, foreign
matters, etc. from fill hole.
|
1. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air cleaner")
|
2. |
Remove the eyebolt (A).
|
3. |
Add ATF SP-IV 700cc to the ATF injection hole.
|
4. |
Start the engine.
|
5. |
Confirm that the temperature of the A/T oil temperature sensor
is 50~60°C (122~140°F) with the GDS.
|
6. |
Shift the select lever slowly from “P” to “D”, then “D” to “P”
and repeat one more at idle.
|
7. |
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
|
8. |
Remove the fluid level plug (A) from the valve body cover.
|
9. |
If the fluid flows out of the overflow plug in thin steady stream,
the fluid level is correct.
Then finish the procedure and tighten the fluid plug.
|
10. |
Install the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
|
11. |
Lower the vehicle with the lift and then tighten the eyebolt.
|
12. |
Install the air cleaner assembly.
(Refer to Engine Mechanical System - "Air cleaner")
|
Air cleaner filter Cleaning
1. Blow compressed air as shown in the illustration to clean it. ...Automatic transaxle Replacement
1. Remove the under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover") 2. Remove the drain plug (A) and dr ...See also:
Power Door Lock Switch Diagnosis With GDS
1.
The BCM can be diagnosed by using the GDS. The BCM communicates
with the GDS which then displays inputs and outputs along with codes.
It will be able to ...
CVVT Operation Principle
The CVVT has the mechanism rotating the rotor vane with hydraulic force
generated by the engine oil supplied to the advance or retard chamber in accordance
with the CVVT oil control valve con ...
Starter Disassembly
1.
Disconnect the M-terminal (A) on the magnet switchassembly.
2.
After loosening the 2 screws (A), detach the magnet switch assembly
...