Clutch Release Cylinder Air Bleeding
Procedure |
•
|
Use the specified fluid. Avoid mixing different brands
of fluid.
|
|
1. |
After disconnecting a cap from the clutch release cylinder air
bleeder, insert a vinyl hose in the plug.
|
2. |
Refill the clutch master cylinder with the specified fluid.
Specified fluid:
SAE J1703 (DOT 3 or DOT 4)
|
|
3. |
Loosening the plug screw, press and release the clutch pedal about
10 times.
|
4. |
Tighten the plug (A) during the clutch pedal pressed. Afterwards,
raise the pedal with a hand.
|
5. |
After pressing the clutch pedal 3 times more, loosen the plug
(A) and re-tighten it with the pedal pressed. Raise it again, then.
|
6. |
Repeat the step 4 two or three times.
(until there is no bubble in the fluid)
Tightening torque:
6.8 ~ 9.8 N.m (0.7 ~ 1.0 kgf.m, 5.0 ~ 7.2 lb-ft)
|
|
7. |
Refill the clutch master cylinder with the specified fluid.
Specified fluid:
SAE J1703 (DOT 3 or DOT 4)
|
|
1.
Install in the reverse order of removal.
Apply the specified grease to ...
See also:
Special Service Tools
Tool Name / Number
Illustration
Description
Engine support fixture (bar)
09200-3N000
Used for holding engine assembly when removing
/ in ...
Windows
(1) Driver’s door power window switch
(2) Front passenger’s door power window switch
(3) Rear door (left) power window switch
(4) Rear door (right) power window switch
(5) Window opening and ...
A/C Pressure Transducer Description
The A/C Pressure Transducer (APT) converts the pressure value of high
pressure line into voltage value after measuring it. By converted voltage value,
engine ECU controls the cooling fan by o ...